*** This readme file was included in the first version software, dated 1980. 
The program included with this readme is a later software revision, so the 
below information might not apply. 

		IC-1001 Logic Analyzer PC Utility
		=================================

This LA.EXE program allows you to interface your IC-1001 Logic Analyzer with
a PC-compatible computer.  

For computers with a 4.77 MHz. system clock, select 9600 baud to avoid
occasionally missing a byte of data from the Analyzer.  Use 19200 baud for
computers with a 6 or 8 MHz. system clock.

Make sure the Analyzer is jumpered for the proper baud rate before you turn it
on.  Install a jumper plug at J105 to select 9600 baud; remove all of the
jumpers for 19200 baud.  (Install unused jumper plugs over a single pin to
avoid losing them.)

Refer to the Analyzer manual for information on preparing the serial cable, and
connect it between the Analyzer and either the COM1 port or COM2 port (if
available) on the computer.

If you have an extended graphics card in your system, configure it for the
80-column by 25-line color mode.  You may use SETUP in Heath/Zenith
200-series systems - you may have to set DIP switches in other computers.

Turn on the Analyzer and type one of the following commands to run the program:

	LA COM1 9600 
	LA COM1 19200
	LA COM2 9600
	LA COM2 19200

The program will save the specified port and baud rate, so you may simply type
'LA' to rerun the program as long as the port and baud rate are not
subsequently changed.

The program will request that you configure the Analyzer, and after a couple of
seconds the Configuration menu will be displayed.  A sample of data will also
be displayed to allow you to familiarize yourself with the operation of the
Analyzer without having to connect the clips to anything.  The sample is named
'DEMO.NDL', which is representative of data you might acquire with the Analyzer
in Non-delay mode.  Pressing 'T' for Toggle will display a second page of
sample data named 'DEMO.DLY', which is representative of data in Delay mode.

Press 'H' for Help as required.

